1100mm wide x 650mm high x 1mm Flat Stainless Steel Splashbacks
Our standard stainless steel splashbacks are manufactured from a 0.9mm thick grade 430 stainless steel. They can be easily fixed and sealed to a wall using silicone adhesive or similar and come in various thickness options with some finished and wrapped over on the face and four edges, the corners are not welded but can be for a small additional charge.
Should you require an alternative size grade or thickness please email firstname.lastname@example.org for a quotation. All prices shown on these standard worktops are inclusive of VAT and delivery.
Note: DO NOT REMOVE THE PROTECTIVE PLASTIC COATING UNTIL INSTALLATION IS COMPLETE.
We recommend that you leave approximately 1mm around each edge of the splashback to allow for material expansion.
Apply a suitable adhesive to the rear surface of the splashback.
Use a silicone, ‘Grip Fill’ or similar product.
Apply the splashback to the wall and push firmly to the wall to ensure a good contact between the wall and the adhesive. Always refer to the adhesive manufacturers instructions regarding the length of time required for the adhesive to cure or dry. The splashback will need to be supported during this period to ensure it does not separate from the wall.
Once the glue or adhesive is fully cured or dried, you may now remove the protective plastic coating.